Duties and Responsibilities
CAD Operator,
Development of the customers products on CAD.
Liaise with Customers’ engineers developing products from CAD through the prototype phases into production.
Update the company’s drawings,
Design and draw the company’s production tooling.
Prototype manufacture through to serial production.
Working with M.D., to manufacture protype parts to meet the customer requirements.
Document each phase with interim works instructions.
Test completed parts to drawing requirements.
Initiate the FMEA, control plan, flow chart documentation, progressing them through the build phases into the final PPAP pack.
Carry out ‘Run at Rate’ studies where applicable.
Prepare IMDS for all new products as applicable.
Liaise with Customer Quality Department in the PPAP approval process. Incoming Inspection
. Inspection of incoming goods in support the administrator
Reject any batch and issue 8D report to supplier.
Manage 8D Reporting system for supply base.
Maintain Quality objectives. Introduction of new child parts.
Inspect part to FPI or customer drawing.
Complete supplier ISIR procedure.
Raise audit record sheet. Calibration.
Maintain in-house calibration system.
Internal Audits
Carry out internal audits as requested by the quality director. External Audits
Carry out external audits. MSA
Carry MSA studies annually with Q.D.
New Part Introduction Process
Customer Rejection procedure.
Raise or complete 8D inspection report.
Liaise with customer to either replace or rework parts.
Investigate customer concern with works supervisor and establish root cause.
Complete 8D report and return to customer.
Update PPAP documentation if required.
Update works instruction.
Manage the company PPM quality objective.
Lessons Learned Log
Continuous Improvement and Preventive Action Logs
Change Control system.
Lessons Learned records.
Cost of Quality records.
Maintenance of the company’s plant and equipment.
Maintenance of critical spares